New 50mm/45mm pin Miller Backhoe Excavator Mechanical Spring Quick Hitch Coupler Suit Caterpillar

DESCRIPTION

New Miller Backhoe Excavator Mechanical Quick Hitch Coupler to suit Caterpillar Backhoe 416D, 416E, 420D, 428 C3, 428 C3D, 432 C3, 438 C3 and possibly other 3-9 Ton Excavators.

Want a quick hitch but don't have any spare auxiliary hydraulic lines for a hydraulic hitch? This hitch is identical to a hydraulic hitch setup except you lever the pin clasp open and closed with a rod that compresses the spring.

There is no need to pull either of the pins out of your buckets etc. and try to line up the linkages. Instead you simply sit the hitch into your bucket's front pin just like a full hydraulic hitch, then lever the rear spring open and close the coupling over the bucket's rear pin.

Condition is new but was sitting in a warehouse for years and started rusting. We have cleaned it up and given it a paint so it's ready to go.

Comes with the 20mm solid Lever Rod to open and close it: 450mm Long, 1.2kg.

Pin Setup (where your machine's Dipper Arm goes in):
* Front Pin Diameter: 50mm.
* Front Pin BTE: 256mm Between the inside Ear Bosses.
* Rear Pin Diameter: 45mm (this could easily be bored out to 50mm).
* Rear Pin BTE: 207mm Between the inside Ear Bosses.
* Both Front and Rear Pin Bosses can be shaved back up to 263mm (between the Ear Plates) if you need more inside width for your excavator's dipper arm to fit in.
* Pin Center to Pin Center: 345mm.

Pin Setup (where the Hitch sits into your bucket's Headstock):
* Front Pin Diameter: 50mm.
* Front Pin BTE: 253mm width.
* Rear Pin Diameter: 45mm (this looks like it could also accommodate a 50mm Pin).
* Rear Pin BTE: 196mm width.

*** As a 50mm / 45mm Pin Setup (Current):
Should fit: Caterpillar 416D, Caterpillar 416E, Caterpillar 420D, Caterpillar 428 C3 Linkage, Caterpillar 428 C3D, Caterpillar 432 C3 Linkage, Caterpillar 438 C3 Linkage.
Maybe fit: Case 528 and possibly other machines with similar pin spacings.

*** As a 50mm / 50mm Pin Setup:
Should fit: JCB 3CX Std to Suit G65 Bush, MacMotor M8M.
Maybe fit: Kato 180 and possibly other machines with similar pin spacings.

Hitch dimensions: 322mm Wide, 575mm Long, 265mm High. Weight: 64kg.

Call if you would like to discuss or to come inspect it.

We are at
You can pick up, we can deliver to a reasonable distance for an agreed fee, or we can arrange freight within Australia.

(MIC_959AE220825200)